(22) AT unit connection / disconnection
1. Remove the set screw
of the AT link unit (front)
and take out the second thread tension
. ((21) Refer
to “Second thread tension connection / disconnection.”)
2. Draw out the cotter pin
from the pin block
(H type) or
(S type) of the AT link unit (rear)
. Be careful
not to drop the washer
at that time.
3. Lift the AT joint block
of the AT unit upward to remove the block from the pin block
(H type ) or
(S
type) of the AT link unit (rear)
.
4. Draw out the AT link unit (front)
from the plane side (in the direction of the arrow
E
) and remove it.
5. Remove the two set screws
and take out the AT solenoid unit
.
6. For reassembly, follow the steps of 5. to 1. above.
– 37 –
E
Procedures of disassembling
F
Close contact