1. Hold down the X fixed race (rear)
in the direction of the arrow to
tighten 4 set screws
.
2. Loosen 4 set screws
.
3. Hold down the X fixed race (front)
in the direction of the arrow to
tighten 4 set screws
. * Then, adjust the retainer compensating
torque between 9.8 to 39.2 N (1 to 4 kgf) on both right and left sides.
4. Tighten 4 set screws
.
*
Retainer compensating torque: This is a load necessary to move the
race table
after the retainer
has come in contact with the X
stopper
.
This torque should be measured when the belt is slack before pulse
motor installation.
– 42 –
Adjustment Procedures
Results of Improper Adjustment
