1. Remove 4 set screws
to remove the presser plate
, and replace
the old presser plate sheet
with new one.
2. After mounting the presser plate
, adjust the height of the slider
with 4 set screws
. To position the height, lightly press the slider
to the presser plate
when the presser goes up.
o If the position where the presser
plate sheet
was pasted is
w r o n g , a b r a s i o n o f r e l a t e d
components or peeling of the
presser plate sheet
may occur
resulting in a feed error due to
direct contact between the slider
and presser plate
.
o Wrong slider
height may cause
a feed error.
– 48 –
Adjustment Procedures
Results of Improper Adjustment
