(41) Adjusting the needle thread clamp sensor
When the needle thread clamp support plate complete
is withdrawn by 3 to 4 pulses from the needle thread
clamp position (Caution 1., 2.) the clearance A toward the needle thread clamp
becomes 0.
(Caution) 1. The needle thread clamp position is known as the position returned by one step from the
most advanced position when the key is pressed after the origin retrieval by the Test
Mode I08 (IP-400) or CP-7 (CP-20).
2. According to the thread clamp specifications, the memory switch U69 may change.
S Type
→
→
→
→
→
0
H Type
→
→
→
→
→
1
– 63 –
Standard Adjustment
C
B
A
3 to 4mm
1.7 to 2.3mm