– 92 –
5. Supplemental remarks of each function number and explanation of
each function
(1) Feeding frame operational sequence setup
For the AMS-210E, it is possible to change the method of feeding frame and pedal operation by means of a memory
switch.
1. Presser driving type setup
Using the memory switch K74, it is possible to set up the feeding frame of the pulse
motor driving type and the air driving type.
Setup
Contents
Explanation
Pulse motor driving
AMS210ESS/EHS-1306
CP20: 0
Air driving
AMS210ESL/EHL-1306/1510/2206/2210
CP20: 1
2. Feeding frame driving way setup
By changing the memory switches K80 and K83, it is possible to set up feeding frame and pedal operation.
(1) Automatic lowering or lifting
The memory switch K80 is used to set up the operational sequence of the feeding
frame, irrespective of pedal operation at the time of READY key ON, feeding frame
lifting with a temporary stop command in the pattern data, presser lowering key ON,
and so on.
Setup
Contents
Explanation
0 to 99
All lowering, all lifting
All lowering, all lifting only
(2) Feeding frame ON/OFF operational sequence by ordinary pedal operation
Using the memory switch U81, it is possible to set up the operational sequence of the
feeding frame by ordinary pedal operation.
In regard to the setup items, refer to the [(5) List of feeding frame and pedal setup].
(3) Feeding frame ON/OFF operational sequence by a temporary stop command
Using the memory switch U82, it is possible to set up the operational sequence of the
feeding frame by pedal operation while the feeding frame is lifted by a temporary stop
command in the pattern data.
In regard to the setup items, refer to the [(5) List of feeding frame and pedal setup].
(4) Feeding frame lifting at the end of sewing
Using the memory switch K83, it is possible to set up the feeding frame lifting position
in the returning phase from the end of sewing position (end of pattern data) to the start
of sewing position.
Setup
Contents
Explanation
0
Lifting position
The feeding frame is lifted to the top.
1
2-step stroke position
The feeding frame is lifted to the intermediate position
2 to 99
Lifting position
The feeding frame is lifted to the top.
(Caution) This function is enabled with the memory switch U37 when feeding frame
lifting has been set up at the end of sewing.