– 7 –
3-4. Installing the thread stand
1) Assemble the thread stand. Then, put t n thread-stand mountng hole
a
or
B
n the machne table.
2) Tghten locknut
1
to fix the thread stand.
3) When celng wrng s possble, pass the power cord through spool rest rod
2
.
4) If thread sags, use thread stand gude arm (asm.)
3
.
3-5. Installing the air hose
close
open
1) Connectng the ar hose
Connect the ar hose to the regulator .
2) Adjustment of ar pressure
Open ar cock
1
, pull up and turn ar adjust-
ment knob
2
and adjust so that ar pressure
ndcates 0.5 to 0.55 MPa (Max. 0.55 MPa).
Then lower the knob and fix it.
* Close ar cock
1
to expel ar.
3-6. Installing the eye protection cover
WarNING :
Be sure to attach this cover to protect the eyes from the disperse of needle breakage.
Use eye protecton cover
1
after securely attach-
ng t on face plate cover
3
wth screw
2
.
to prevent interference with the feed-
ing frame, be sure to install the thread
stand guide arm (asm.) with the eye
protection cover pressed in the direc-
tion of the arrow.
1
3
2
1
2
3
a
B
1
2
⇧
table
