– 31 –
(2) changing the intermediate presser height value
Press INTERMEDIATE PRESSER button
A
n the
sewng screen to dsplay the ntermedate presser foot heght
reference value settng screen.
Press INTERMEDIATE PRESSER SELECTION button
B
to dsplay the ntermedate presser heght ncrease/de-
crease value selecton screen.
When
C
s pressed, the ntermedate presser heght
ncrease/decrease value selecton screen s dsplayed.
Wth
D
or
E
, needle moves by one sttch n front
or rear n the state that the presser s lowered.
Wth
F
or
G
, needle moves to the needle entry
pont where there s the ntermedate presser command n
front or rear.
When you desre to stop, press STOP button
H
.
Press ORIGIN MOVE button
I
and the needle moves
to the start of sewng poston.
The value whch s dsplayed s the absolute value (ntermedate
presser heght value + ntermedate presser ncrease/decrease
value).
Input the value you desre wth TEN keys and +/– keys
J
.
When ENTER button
K
s pressed, the data s deter-
mned.
1. When checking the needle, or performing the feed
forward or backward, the machine fails to work un-
less the presser is lowered. use the machine after
lowering the presser.
2. When increasing the height of intermediate presser
or making the needle size thicker, confirm the clear
-
ance between the wiper and the components. Wiper
cannot be used unless the clearance is secured. In
this case, turn oFF the wiper switch, or change the
set value of memory switch u105.
B
A
K
J
C
D
F
H
G
E
I
