− 8 −
8. INSTALLING SP-47 (ROLLER STACKER)
(OPTIONAL PART NO. : 40058953)
1
Confirming parallelism
Make sure that stacker
table
4
and rubber roller
3
are installed parallel
with each other.
If not, loosen four
setscrews
2
to adjust.
2
Confirming the clearance
Make sure that the
clearance between
stacker table
4
and
rubber roller
3
is
approximately 0. mm.
If it is not approximately
0. mm, loosen nut
5
to
adjust.
2
0.5mm
3
4
5
(1) Adjusting the position
When the roller stacker is not used or adjusting
the corner knife, the roller stacker can be turned
upward with the procedure below.
Pull release lever
1
. Lift up the roller section to
thrust pin
3
into fixing spring
2
, then bring them
into locked state (see Fig. 1). This puts the sewing
machine in standby state.
(Working state)
(Waiting state)
Fig. 1
1
2
(2) Maintenance
3
