− 21 −
1. PREFACE
2) Folder structure of the media
Store each file in the directories below of the media.
Data that are not stored in the directories above cannot be read. So, be careful.
Media drive
APW895
APW××× .EPD
APW××× .EPD
APW××× .EPD
1) To use the data for APW895/896 (EPD data) on APW-895
To use the EPD data on the APW-895, read the data into the IP-420.
Insert the relevant medium into the IP-420. Select pattern number xxx from EPD data.
3) CompactFlash (TM)
1) Turn the label side of the CompactFlash(TM) to
this side (place the notch of the edge to the rear.
) and insert the part that has a small hole into
the panel.
2) After completion of setting of the media, close
the cover. By closing the cover, it is possible
to access. If the media and the cover come in
contact with each other and the cover is not
closed, check the following matters.
・
Check that the media is securely pressed
until it goes no further.
・
Check that the inserting direction of the
media is proper.
1. When the inserting direction is wrong, panel or media may be damaged.
2. Do not insert any item other than the CompactFlash (TM).
3. The media slot in the IP-420 accommodates to the CompactFlash (TM) of 2 GB or less.
4. The media slot in the IP-420 supports the FAT16 which is the format of the CompactFlash (TM).
FAT32 is not supported.
5. Be sure to use the CompactFlash (TM) which is formatted with IP-420. For the formatting procedure of
-17. Performing formatting of the media", p.92
Media
■
Inserting the CompactFlash (TM)
^
. HOW TO USE THE OPERATION PANEL
