− 57 −
. . . Item that is not displayed due to other setting state
No.
Item
Setting range
/
Edit unit
Initial value
Stacking position
After moving clamp foot as far as the set distance from the position of
corner knife, stacker is actuated. (+ : rear side, - : front side)
＊
Range of actuating amount is limited by the position of clamp foot at
the time of sewing end.
＊
Use
clamp bar stacker or
roller stacker. In addition,
t s possble to set only when
roller stacker moton settng or
clamp bar stacker motion setting is performed.
0 to 500mm
/
1mm
0mm
Stacker timer 1
Roller rotaton tme s set. When materal sensor has detected wthout ma
-
terial before setting time, rotation stops.
＊
roller stacker opton s used and t s possble to set only when
roller stacker moton s set.
0.0 to 9.9
/
0.1 sec.
0.5 sec.
Jump feed speed up to the position of sewing start
Jump feed speed up to the position of sewing start is set.
3 to 8
/
1
5
Jump feed speed up to the position of corner knife
Jump feed speed up to the position of corner knife is set.
3 to 6
/
1
5
Dart stretcher device stop/motion change-over
Stop/motion of dart stretcher device is selected.
＊
It is possible to set only when
dart stretcher opton s used.
- - -
Stop
Moton
Automatic interlining supplying device stop/motion change-over
Stop/motion of automatic interlining supplying device is selected.
＊
It is possible to set only when
automatc nterlnng supplyng
opton s used.
＊
Regardng the nterlnng supplyng, when the pattern s not used, be
careful not to make the interlining come out from the top surface of the
table. When using next, press once the feeding button on the panel
and perform the feeding motion to cut.
- - -
Stop
Moton
