JUKI APW-895NE Instruction Manual Download

Page: 9 / 256

Precautions to be taken so as to use the APW-895NE more safely

1. To avoid accidents caused by electric shock, never open the motor cover, the main body

cover, the control box cover, or the operation panel cover, or touch the components inside the

control box or the operation panel while the power switch is ON.

1. Do not look in the laser beam. Do not directly look directly at the beam with an optical appara-

tus.

1. To avoid personal injuries, when returning the machine head from the raised state to the

home position, return it to the home position after confirming that there is no tool or compo

nent under the gas spring.

2. To avoid personal injuries and damage of sewing machine, do not damage with tools or parts

the rod section of the gas spring located under the machine head.

3. To avoid personal injuries, immediately replace the gas spring with a new one when the rod

section of gas spring does not function properly with a flaw or the like, or it is judged as a

defective one. For the judgment standard of defectiveness, refer to the item of "Standard of

replacing time of the gas spring".

    [Do not use anything other than JUKI genuine gas spring (Part No. : 40023177).]
  4.  To avoid personal injuries, do not use with the gas spring removed.
  5.  Do not put your hand under the needle when you turn ON the power switch or operate the

machine.

6. When depressing the foot pedal, the clamp foot moves at high speed. Do not place your hand,

fingers, or face within the moving range of the clamp foot with your foot on the pedal.

7. Be sure to turn OFF the power switch before tilting the machine head.

8. To protect against possible danger, never place your fingers, hair or anything near the motor

pulley and other driving part while the machine is in operation.

9. If any of the following phenomena should arise, immediately turn OFF the power switch and

have a maintenance personnel inspect the machine.

    (1) In the case where needle breakage or thread breakage frequently arises.
    (2) In the case where the machine exhibits irregular behavior.
10.   Do not turn off the air supply while the sewing machine is in operation.
11.  Do not shift the clamp foot with the sewing table opened.
12.  Be sure to connect the FG wire of the power cable to the earth of the main power source.
13.  Do not place anything that might generate a high heat/humidity around the electrical box.
14.  Use welt patches reinforced with adhesive interlining.
15.  Keep your hands away from the corner knife while the machine is in operation.
16.  For the machine provided with a stacker (optional), attach the safety pipe for stacker to ac-

tivate the stacker. Avoid the use of the stacker with the machine or independently with the

stacker or safety pipe held opened to ensure safety.

17. Do not quickly repeat ON/OFF of the power switch since erroneous motion such as panel ab-

normal indication or the like will be caused. Perform the power ON operation after 5 seconds

or more from turning OFF the power.

18. Be sure to perform drawing/inserting the power plug socket with the power switch OFF.
19. Be careful of handling this product so as not to pour water or oil, shock by dropping, and the

like since this product is a precision instrument.

20. For the work at the position lower than the surface of the wooden table, perform the work pay-

ing attention to the overhead table or the like.

21. To protect personal accident, when lifting or transporting the machine, use the heavy machine

such as the fork lift or the like.

22. Do not place hands under the binder and clamp foot which drop by their own weight when

you operate the emergency stop switch.

23. In a domestic environment this product may cause radio interference, in which case the user

may be required to make corrective actions.