– 24 –
6
5
4
3
7
A part of functon settng tems can be easly changed n the normal sewng state.
(caution) For the setting of functions other than those covered in this part, refer to
[one-touch setting procedure]
) Keep
swtch
7
held pressed for one second
to place the panel n the functon settng mode.
2) Change over the tem to be set by usng
swtch
3
or
swtch
4
. Then, the set value
can be changed by usng
swtch
5
and
swtch
6
.
3) To return to the normal sewng state, press
swtch
7
.
(caution)
The setting is confirmed by pressing
switch
7
. one-shot automatic sewing, material
edge sensor, thread trimming by the material
edge sensor and the number of stitches of the
material edge sensor are not displayed in the
default setting at the time of delivery.
1
Thread trmmng functon (
)
: Thread trmmng operaton s not performed (solenod output prohbton: Thread trmmer, wper)
: Thread trmmng operaton s effectve.
2
Wper functon (
)
: Wper does not operate after thread trmmng.
: Wper operates after thread trmmng
3
One-shot automatc sttchng functon (
)
: One-shot automatc sttchng functon s neffectve.
: One-shot automatc sttchng s effectve.
(caution) this function is rendered effective when the material end sensor function is set. It is not pos-
sible to prohibit the one-shot operation during overlapped sewing operation. the number of revolution
is the value which is set for setting No. 38.
4
Settng of the max. speed of sttch (
)
The hghest speed of sttch of the machne head s set. The upper lmt of the set value dffers wth the
type of machne head to whch the SC s connected.
Settng range : 50 - Max. value [st/mn]
5
Materal end sensor functon (
)
: Materal end sensor functon s neffectve.
: Once the materal end s detected, the sewng machne stops runnng after havng sewn the
number of sttches set wth
7
(
).
* Ths functon s rendered effectve when the materal edge sensor s set wth functon settng No. 2.
6
Thread trmmng functon by materal end sensor (
)
: Automatc thread trmmng functon after the detecton of materal end s neffectve.
: Once the materal end s detected, the sewng machne performs thread trmmng after havng
sewn the number of sttches set wth
7
(
).
* Ths functon s rendered effectve when the materal edge sensor s set wth functon settng No. 2.
7
Number of sttches for materal end sensor (
)
The number of sttches to be sewn from the detecton of materal end to the stop of the sewng machne
Number of sttches that can be set: 0 to 9 (sttches)
(caution) this function is rendered effective when the material end sensor function is set. If the number of
stitches specified is inadequate, the sewing machine can fail to stop within the preset number of stitches
depending on the number of revolutions of the sewing machine.
8
Adjustment of quantty of lght of LED lght
（
）
The quantty of lght of the LED lght s adjusted
Settng range : 0 to 00
4. one-touch setting
