45
Groove
Button holder
1
Set the presser foot.
Push the needle up/down button to raise the needle
and lift the presser foot.
Align the groove of the presser foot holder with the pin
of the presser foot and lower the presser foot holder to
set.
2
Set the button.
Pull the button holder toward
A
, place the button on
the button holder, and then push the holder toward
B
to set the buttonhole length.
* It is impossible to set a button thicker than
4mm.
Pin
A
B
3
Set the buttonhole sensor pin.
Insert the sensor pin into the sensor pin hole at the
face plate cover.
* Insert the pin into the hole completely.
* If the machine starts to sew without inserting
the pin into the hole, the following message will
be shown on the display.
Set the sensor pin
and restart.
Sensor pin
* Check the following
points after setting the
presser foot and then
start to sew buttonholes.
Check that there
is a clearance.
If there is not a
clearance, the
machine will
not sew neat
stitches.
46
4
Place the fabric under the presser foot.
Raise the presser foot, pass the needle thread through
the hole on the presser foot and pull it out sideways.
Place the fabric under the presser foot, align the
marking with the sewing-start point. Penetrate the
needle into the fabric by turning the hand wheel and
lower the presser foot.
5
Start sewing.
The machine will stop automatically after sewing the
buttonhole.
* If a buttonhole of the same size will be sewn
again, push the thread trimming button to trim
the threads and raise the presser foot.
Under this condition move to another point,
lower the presser foot and then start sewing.
* Do not change stitch length and/or zigzag width
during buttonholing. Otherwise this will cause
imbalanced stitches.
* If thread trimming button is pushed while
sewing buttonhole, the machine will stop and
will not complete the buttonhole.
* Depending on material to be sewn and weaving
direction of the material, there might be a slight
difference in zigzag widths between right and left
lines of buttonholes. Test sewing is recommended.
Hole on the
presser foot
Sewing-
start point
Needle
thread
Start from here
Marking
47
Summary of Contents for HZL-600
