10
Additional spool pin
The additional spool pin is for winding bobbins, without
unthreading the machine.
Set the spool stand under the additional spool pin.
Insert the additional spool pin into the hole.
Place the felt and a spool on the pin.
①
Spool stand
②
Additional spool pin
③
Hole for additional spool pin
④
Spool pin felt
The extra spool pin should point to the bobbin winding
tension disk.
Draw the thread from the spool and pass the thread
around the bobbin winding tension disk as shown.
⑤
Bobbin winding tension disk
Setting the Spool of Thread
Horizontal spool pin
Lift up the spool pin. Place a spool of thread on the spool
pin.
Attach the large spool holder, and press it firmly against
the spool of thread so that the spool rests on the
supporter.
①
Spool pin
②
Spool of thread
③
Large spool holder
The small spool holder is used with narrow or small
spools of thread.
④
Small spool holder
Bobbin Winding
Removing the bobbin
Gently slide the hook cover release button to the right
and remove the hook cover plate.
Lift out the bobbin.
①
Hook cover release button
②
Hook cover plate
③
Bobbin
NOTE:
Use the designated plastic bobbins for horizontal
hook. Using other bobbins, such as pre-wound paper
bobbins, may cause stitching problems and/ or
damage to the bobbin holder.
②
①
①
③
④
①
②
④
③
⑤
②
③
