- 6 -
- 6 -
- 6 -
- 6 -
- 6 -
4. Front panel
Preparation required
Remove the top board.
Remove the front cover.
Remove the operating lever.
Disassembly
Assembly
Point to be checked
Loosen screw in the face plate of
the panel.
(You may loosen and tilt the lamp
instead of loosening screw .)
Loosen screw at the center of panel.
Loosen two screws in the bottom of
panel.
· In order to release the engaging
section to eliminate loose fitting,
remove the panel while lifting it.
Assemble through without fail.
· Tighten the four screws which have
been loosened.
Caution:
Make sure that the indicator
connecting cable has been connected.
Fit needle thread guide pin in the
groove on the front panel in the correct
manner.
Face plate cover
guide shaft A
5. Bed base, cylinder bed lower cover
Disassembly
Assembly
Point to be checked
Remove three screws in the rubber
seat A.
Remove three screws in the bed
base.
Remove two screws in cylinder bed
lower cover , and remove the cover.
· Attach the bed base on the frame.
· Fix the bed base by tightening the
screw which have been removed.
· Set the three rubber seat A on the bed
base with accuracy.
[Top surface of the frame]
[Side face of frame (face frame)]
[Bottom view of frame]
Center screw of panel
Screw at the bottom of panel
Screw in the side
face of panel
Engaging section to
eliminate loose fitting
Needle thread guide pin
Engaging section of the panel
Engaging section at the center of panel
Needle bar
connecting rod
Main shaft
Bobbin winder shaft
k
o
n
j
k
l
o
m
n
k
j
k
m
n
j
k
l
Screw in the bed base
Screw in the
cylinder bed
lower cover
Screw in the rubber seat A
j
k
l
l
