– 9 –
Sewing can be performed with the production support data displayed on the control panel.
[Basic operation of the production support modes]
1) When
switch
7
is pressed in the nor-
mal sewing state, LED
E
lights up to enter
the production support mode.
2) Production support function can be changed
over by pressing
switch
3
or
switch
4
.
3) Data attached marked with (*1) in Table 1
"Indicator
A
" can be changed by means of
switch
5
and
switch
6
.
4) When you keep
switch
6
held pressed for two seconds, indicator
B
and LED
E
flash on and off. While
they are flashing on and off, data marked with (*2) in Table 1 "Display under modes" can be changed by press
-
ing
switch
5
and
switch
6
.
When you press
switch
7
, the value marked with (*2) is confirmed and indicator
B
and LED
E
stop
flashing on and off.
5) The value with a sharp mark (*3) in Table 1 "Display of modes" can be changed only immediately after reset-
ting by using
switch
5
and
switch
6
.
6) Refer to the table "Mode resetting operation," for the resetting procedure of data.
7) To return to the normal sewing state, press
switch
7
.
Data to be displayed under the respective modes are as described in the table below.
Mode name
Indicator
A
Indicator
B
Indicator
B
(when
switch
5
is pressed)
Target No. of pcs. display
mode (F100)
Actual number of pieces
[Unit : piece] (*1)
Target number of pieces
[Unit : piece] (*2)
-
Target/actual No. of pcs.
difference display mode
(F200)
Difference between target
number of pieces and
actual number of pieces
[d : piece] (*1)
Target pitch time
[Unit : 100 msec] (*2)
-
Sewing machine availabili-
ty rate display mode (F300)
oP-r
Sewing machine avail-
ability rate in the previous
sewing [Unit : %]
Display of average avail-
ability rate of sewing
machine [Unit : %]
Pitch time display mode
(F400)
Pi-T
Pitch time in the previous
sewing [Unit : 1sec]
Display of average pitch
time [Unit : 100 msec]
Average
sewing
speed
display mode (F500)
ASPd
Average sewing
speed
in
the previous sewing [Unit :
sti/min]
Display of average sew-
ing
speed
[Unit : sti/min]
Bobbin counter display
mode
bbn
Bobbin counter value (*3)
-
Table 1: Display of modes
7
3
4
5
6
E
A
B
