– 15 –
1. Pass the two lubrication pipes
and the oil drain pipe
through the frame, and mount the shuttle
.
2. Hold the lubrication pipe
with the lubrication pipe holder plate
and fix it with the set screw
.
At that time, make sure not to let the lubrication pipe
come in contact with the thread cutter connector
rod.
3. Pass the lubrication pipe
through the cord clamp
and fix it with the set screw
At that time, the needle thread clamp sensor cord
should be passed beneath the lubrication pipe
and
the oil drain pipe
.
If the needle thread clamp sensor cord
is located above them, this can be a cause of abrasion or cable
breakage in the crosswise feed main
.
4. Using the harness band
and the lubrication pipe holder
, stretch and fix the lubrication pipe
along
the wall side of the frame.
At that time, make sure not to permit the lubrication pipe
to touch the needle thread clamp connector link.
5. Bundle the needle thread clamp sensor cord
, the lubrication pipe
, and the oil drain pipe
with the
harness band
.
6. Pass the two oil drain pipes
through the cord clamp
and fix them with the set screw
.
7. Insert the two oil drain pipes
(part B) in the oil tank
. Fix the oil tank
to the frame with the set screw
.
8. Fix the oil drain pipe
to the rear side by means of the cord clamp.
9. Fix the shuttle
and mount the driver
. Refer to [(10) Hook adjustment].
*
Harness bands
and
: Part No. EA9500B0100
Procedures of assembling
Bring needle bar
to the lowest position of its storoke. Loosen needle
bar connection screw
and adjust so that upper marker line
engraved
on the needle bar aligns with the bottom end of needle bar bushing
lower
.
(Caution) After the adjustment, make sure that there is no uneven
torque.
* When stitch skipping occurs in accordance with the sewing condi-
tions, adjust the height of the needle bar so as to lower it by 0.5 to
1mm from the neddle bar engraved line
.
Adjustment Procedures
Results of Improper Adjustment
Summary of Contents for LK-1900A
