– 31 –
1. The position of the mechanical origin is shown in the illustration at
left.
2. In the horizontal direction, the needle hole center
<center of the
horizontal feed fulcrum shaft
> and the center of the vertical feed
fulcrum shaft
are aligned on a straight line.
3. Adjustments should be carried out according to 1) (22) Adjusting the
Y origine sensor and (23) Adjusting the X origin sensor.
Adjustment Procedures
Results of Improper Adjustment
o The maximum area cannot be
secured.
1. Select the test mode No. 2 (CP-2) origin retrieval.
2. Origin retrieval is conducted each time the pedal is trodden on.
Loosen the sensor slit set screw
and shift the position of the sen-
sor slit plate
. Apply the work feed plate to the origin position.
Refer to “ (21) Position of the mechanical origin.”
(Caution) After adjustments, confirm that the sensor slit plate
does not interfere with the sensor
.
Adjustment Procedures
Results of Improper Adjustment
Summary of Contents for LK-1900A
