–
9
–
Standard Adjustment
1. Position of the needle thread guide rod
(1) It is the standard that the height of needle thread guide rods
1
is the position where the dimensions from the top
surface of needle thread guide base
2
to the bottom end of the hole are as follows.
Left needle A : 7 mm
Middle needle B : 15 mm
Right needle C : 23 mm
2. Adjusting the position of needle thread guide base and silicon container thread guide
(1) It is the standard that the height of silicon containder thread guide
4
(refer to 2. CONFIGURATION OF THE
MACHINE COMPONENTS) is the position where the height from the center of setscrew
5
to the bottom end of
thread hole is 9 mm.
(2) Move the lateral position of needle thread guide base
2
fully to the right of slot (43 mm).
Extreme right position
C
B
A
A : 7mm B : 15mm C : 23mm
1
2
3
Extreme right position
7
43mm
9mm
5
4
6
2
(3) Adjusting the position of the needle thread guide rod
