ENGLISH
83
Press the SET button. The hour digits 10 flash.
Set the correct hour using the + and - buttons.
Press SET again. The minute digits 00 flash.
Set the correct minutes using the + and - buttons.
Press SET again. 55°C flashes.
Set the required switch-off temperature for auxiliary heating using the + and - buttons.
Press the ESC button to save the settings and close the parameter setting.
Press +. tH 3o 17:00 appears on the display to indicate that you can set the switch-on time and
temperature for the third auxiliary heating period.
Press the SET button. The hour digits 17 flash.
Set the correct hour using the + and - buttons.
Press SET again. The minute digits 00 flash.
Set the correct minutes using the + and - buttons.
Press SET again. 50°C flashes.
Set the required switch-on temperature for auxiliary heating using the + and - buttons.
Press the ESC button to close the parameter setting and go to the switch-off time and temperature
setting.
Press +. tH 3F 22:00 appears on the display to indicate that you can set the switch-off time and
temperature for the third auxiliary heating period.
Press the SET button. The hour digits 22 flash.
Set the correct hour using the + and - buttons.
Press SET again. The minute digits 00 flash.
Set the correct minutes using the + and - buttons.
Press SET again. 55°C flashes.
Set the required switch-off temperature for auxiliary heating using the + and - buttons.
Press the ESC button to save the settings and exit the sub-menu. The settings are saved
automatically and the menu is closed after 20 seconds of inactivity.
NOTE:
If there is no gas or oil-powered hot water heater in the system, an electric heater can be installed
as a standby. When the electric heater is switched on,
flashes on the display.
If the electric heater is used, the controller must be supplemented with an appropriate contactor/switch.
Main menu TEMP (temperature)
Appropriate operating temperatures are factory set and rarely need to be changed. Note the operating
data for all system components if the parameter settings are changed in the current application.
NOTE
: It may not be possible to change all parameters. The changes that are possible depend on the
specific application.
