ENGLISH
91
Press SET again. The third digit flashes.
Use the + and - buttons to set the third digit of the password.
Press SET again. The fourth digit flashes.
Use the + and - buttons to set the fourth digit of the password.
Press the SET button. PWDN 0000 is displayed to show that you can enter a new password.
Follow the instructions above to enter a new password.
Press the SET button. PWDG 0000 is displayed to show that you can enter the new password
again. Follow the instructions above to enter the new password again. PWOK is displayed.
Press the ESC button to save the settings and exit the menu. The settings are saved automatically.
The menu closes after 20 seconds of inactivity.
WARNING:
It is not possible to retrieve the password if you have forgotten it. However, you can reset the unit to the
factory settings as described below. The password then reverts to the default factory setting. You can
then enter a new password. Note that all settings will be lost when you revert to the factory settings.
Open the door on the controller. Hold down
and press the reset button.
Three beeps are heard. Release the button. The controller resets to factory settings and you can
enter a new password.
LOAD: Reset to factory settings
Setting
Open the main menu and the REST sub-menu. Press SET. YES is displayed.
Hold down the SET button until three beeps are heard. The controller resets to factory settings and
you can enter new parameter values.
Press the ESC button to save the settings and exit the menu. The settings are saved automatically.
The menu closes after 20 seconds of inactivity.
Power switch
The controller must be in standby.
Hold down the power switch
for 3 seconds. The controller switches off. OFF is displayed.
Press the power switch
again to switch on the controller.
