EN
27
Operating the compressor without pre-set pressure
1.
Set the pre-set pressure to zero by pressing the minus (-) pressure adjustment button (E)
multiple times until the value reaches ”0”. When the pre-set pressure is “0”, it means that
the compressor will work without the pre-set function.
2.
Pull out the 12V cord from the side compartment and connect the plug to the vehicle’s
cigarette lighter socket.
3.
Connect the quick connector to the tyre’s valve and press the locking connector down
to secure the connection.
4.
Start the vehicle’s engine. The compressor is now ready for use.
5.
Press unit selection button (F) to select the desired pressure unit. The display is always
illuminated so the compressor is easy to use even when it is dark.
6.
Press the compressor button (A) until the tyre has reached the correct pressure.
7.
Remove the quick connector from the tyre and disconnect the 12V plug.
BATTERY TEST
Note:
•
Do not turn on the vehicle’s engine when using this function.
•
Different types of vehicles can have different battery voltages. Read the vehicle’s manual
or contact the manufacturer for more information.
1.
Pull out the 12V cord from the side compartment and connect the plug to the vehicle’s
cigarette lighter socket.
2.
Press the button
to activate the battery test mode. The actual battery voltage
will now be shown in the display.
– LOW: the battery voltage is too low. The battery should be checked or replaced.
– MID: the battery voltage is moderate.
– FULL: the battery voltage is OK.
Summary of Contents for 604-195
Page 30: ......
