21
The adjustment lever also extends the use of the cutting blades, as different cutting edges are used
for the different settings.
You can also use the adjustment lever to remove very thick hair that catches between the two
cutting blades, without needing to dismantle the blades. While the machine is running, move the
adjustment lever rapidly from the lowest position to the highest a few times. Do this after each use
to keep the cutting blades free from cut hair.
If the machine stops cutting or does not cut well, and the above action does not rectify the problem,
the blades have become worn and therefore need to be replaced.
Preparation
1.
Inspect the machine and check that there is no oil between the cutting blades’ teeth. Turn on the
machine to distribute the oil. Check that the machine is working evenly without jamming. Wipe off
surplus oil. This must be done each time after use. Keep an eye on the power cord to ensure it
does not become entangled while working.
2.
Position the person whose hair is to be cut so that their head is roughly level with your eyes. This
gives you a good view of the head and the machine is easy to operate.
3.
Comb the hair to remove any tangles.
4.
Place a towel around the person’s neck and over their shoulders.
Cutting
Cutting hair requires practice and experience. It is therefore advisable to allow the hair to grow a
little longer the first few times you cut it, until you are accustomed to how much each accessory
comb cuts.
Cut the hair with slow, relaxed movements. Use short movements to gradually cut the entire head.
Only cut off a little hair at a time. You can always trim off more hair afterwards if necessary.
While working, comb the hair frequently back to the style you want to cut.
It is easier to cut dry rather than wet hair with this machine. It is then much easier to see how much
hair has been cut off.
Accessory combs (see Accessories)
Accessory comb no. 1 cuts the hair to a length of 3 mm.
Accessory comb no. 2 cuts the hair to a length of 6 mm.
Accessory comb no. 3 cuts the hair to a length of 9 mm.
Accessory comb no. 4 cuts the hair to a length of 12 mm.
Each accessory comb is marked on the outside with the number of mm.
In order to fit a comb, hold it with the teeth facing up and slide it on along the cutting blade until the
front of the comb is properly in contact with the blade.
To remove a comb, simply pull it up and away from the cutting blade.
For an even cut, allow the comb/cutting blade to do the work. Let them cut through the hair. Do not
force the machine quickly through the hair. Remember to comb the hair frequently to remove cut
hair and release uneven long strands of hair.
Step 1
– back of the neck
1.
Fit the “3 mm” or “6 mm” accessory comb.
2.
Hold the machine pointing up and start cutting in the middle at the base of the back of the neck (fig.
5).
3.
Hold the machine so that is fits comfortably in the hand. Hold it gently against the head with the
teeth pointing up. Lift the machine gradually and slowly, and work upwards and outwards through
the hair so that you only cut a little hair at a time.
4.
While cutting, lift the machine gradually towards you. Continue to cut the rear area from the bottom
edge of the back of the neck up to the ears.
