Jump n Carry JNC4000, Manual

Features

•  The Jump-N-Carry provides plenty of power for starting vehicles – more than 

enough to start most cars.

•  The Jump-N-Carry will power most 12 Vdc accessories equipped with a male  

12 Volt plug. The DC outlet features automatic overload protection.

•  The unit features a test switch and battery status gauge, which provides an 

approximate indicator of the battery’s state of charge.

•  The Jump-N-Carry features convenient side-mounted holsters with cable tracks 

for easy cable and clamp management. Always re-wrap cables and re-holster the 

clamps after each use.

•  The Jump-N-Carry contains the latest technology with its 12 Volt sealed,  

non-spillable battery and may be stored in any position.

Recharging

Note:  Upon initial purchase, charge your Jump-N-Carry until the green CHARGED  

LED lights.
There are two ways to charge your Jump-N-Carry. The recommended method is 

recharging using AC power, with a household extension cord connected to the built-in 

charger. An alternative method is through the DC power outlet using the provided 12 

Volt Male-Male Extension Cord. 
Charging using the built-in charger (recommended method). With this method, an 

extension cord (not included) is connected to the Jump-N-Carry through the built-in 

charger located on the front of the unit.

1.  Connect the female end of the extension cord to the charger plug on the front of 

the unit. The charger plug has two blades and resembles a standard household 

plug that would fit into a 120 Vac wall receptacle.

2.  Connect the male end to the extension cord to the AC outlet.

     - an amber LED will light to show the charging phase is in process. 
  3.    Charge until the green LED lights to show that the charging process is complete 

and has entered maintenance mode.

  Note: The unit can remain connected to AC power indefinitely without adverse 

consequences. The charging system is fully automatic and will only consume 

power as need to maintain the onboard battery.

Battery Status Gauge

Press and hold the red test button to display the battery status on the gauge.

•  The Green shaded area indicates the unit is capable of jump starting.
•  The Yellow shaded area indicates the unit needs to be recharged.
•  The Red shaded area indicates the unit must be recharged immediately.

You can also get a quick check of the vehicle’s charging system by depressing the red 

test button while connected to a running vehicle and observing the gauge.