6
ASSEMBLY
IMPORTANT ASSEMBLY INFORMATION
• Assembly requires a 9/16” socket and ratchet (or
a 9/16” open-end wrench) and a Philips screw-
driver (not included).
• Assembly requires two adults. Keep children
away from the trampoline enclosure until it is fully
assembled.
• Use gloves to protect your hands from pinch
points during assembly.
• Make sure that the trampoline is properly assem-
bled, with the frame pad properly attached, before
you assemble the trampoline enclosure.
• The assembly steps refer to parts by their
descriptions and key numbers (see the PART
LIST on page 11).
• Refer to the EXPLODED DRAWING AND PART
LIST on page 11 and make sure that all listed
parts are included. If a part is missing, refer to
ORDERING REPLACEMENT PARTS at the bot-
tom of page 11.
TRAMPOLINE PLACEMENT
1. Place the trampoline and enclosure on a level
surface before use.
2. Adequate overhead clearance is essential. A
minimum of 24 feet from ground level is rec-
ommended. Provide clearance for wires, tree
limbs, and other possible hazards. Lateral
clearance is also essential. Place the trampo-
line and enclosure away from walls, struc-
tures, fences, and other play areas. Maintain a
clear space on all sides of the trampoline and
enclosure.
3. Use the trampoline and enclosure in a well-
lighted area. Artificial illumination may be
required for shady areas.
4. Secure the trampoline and enclosure against
unauthorized and unsupervised use.
5. Remove any obstructions from beneath the
trampoline and enclosure.
6. The trampoline enclosure is only to be used
as an enclosure for a round trampoline.
1. Make sure that you understand the informa-
tion in the box at the top of this page before
you begin assembling the trampoline enclo-
sure.
Loosen the straps (not shown) on the underside of
the frame pad (for clarity, the frame pad is not
shown in steps 1 and 3). Do not remove the
frame pad from the trampoline.
Refer to the inset drawing. Thread a Jam Nut (1)
as far as possible onto a Clamp Screw (2). Thread
another Jam Nut onto another Clamp Screw.
Thread both Clamp Screws a few turns into one of
the Clamps (3). Repeat this step with all of the
Jam Nuts, Clamp Screws, and Clamps.
Lift one of the trampoline sockets off the leg below
it. Slide a Clamp (3) down onto the leg. Slide the
socket back onto the leg. Slide a Clamp onto
each of the legs in the same way.
3
Leg
Socket
1
1
2
2
1
3
Note: For clarity, the
frame pad is not shown.
Do not remove the frame
pad from the trampoline.
