i
After the battery is inserted the red LED lights up for approx. 1 minute. After that the motion
detector is in the walking test/teach mode for approx. 10 minutes (see chapter Teaching
motion detector in radio receiver). This is displayed by rapid flashing of the LED. No
actuator may be in programming mode during this time. Otherwise undesirable teaching
will take place.
4.2 Commissioning
Teaching motion detector in radio receiver
In order for a receiver to understand a radio telegram from the motion detector, the receiver has
to "learn" this radio telegram. The motion detector can be taught in any number of radio
receivers. The teaching procedure only results in an assignment in the radio receiver.
When teaching a radio transmitter, the range of the receiver is reduced to about 5 m. The
distance between the radio receiver and the transmitter being taught should therefore be
between 0.5 m and 5 m.
o
Remove battery from the motion detector for approx. 2 minutes.
o
Insert battery again.
After the battery is inserted the red LED lights up for approx. 1 minute. Then the motion
detector is in walking test/teach mode for approx. 10 minutes. This is displayed by rapid
flashing of the LED. In this mode the motion detector evaluates motions regardless of the
brightness. Every telegram transmitted here can be taught in the radio receiver.
o
Test the detection area by walking over it and mount push-on cover if necessary (see
"Limiting the detection area").
Each telegram transmitted switches the receiver on for approx. 2 seconds.
i
If the motion detector does not detect any motion for approx. 2 minutes, then it
automatically exists the walking test / teaching mode.
o
Switch radio receiver to programming mode (see instructions for receiver).
o
Make a motion in the detection field of the motion detector so that it transmits a teaching
telegram.
The red LED of the motion detector flashes approx. 4 times.
The radio receiver acknowledges the teaching procedure (see instructions for the radio
receiver).
o
Exit programming mode of the radio receiver (see instructions for the radio receiver).
Setting the sensitivity and brightness setpoint
Figure 9: Adjuster under cover
o
Pry out cover (3) carefully from below using a screwdriver.
o
Use the sensitivity controller
Sens.
(6) to adjust the sensitivity of the sensor between
maximum and minimum sensitivity (figure 9).
6/8
32552843
J0082552843
16.08.2016
Radio Management
Radio automatic switch 180°
