o
Use the brightness setpoint controller (7) to adjust the brightness setpoint:
Symbol Moon: approx. 0 lux,
Just before the Sun symbol end stop: approx. 80 lux,
Sun symbol end stop: brightness-independent switching or daytime operation.
The change in the setting is only applied when no motion is detected for 2 minutes.
i
Set the brightness setpoint on the radio motion detector to approx. 80 lux in connection
with a radio power pack. This value is located just before the end stop in the direction of
the Sun symbol. The desired brightness threshold can then be set directly on the radio
power pack.
i
The run-on time is specified by the radio actuators. The run-on time can be set from
10 seconds to 15 minutes on the motion detector power pack. For switch and dimmer
actuators the run-on time is approx. 1 minute.
Limiting the detection area
Figure 10
The supplied cover plate (10) can be used to mask unwanted detection areas (figure 10). The
cover plate can cover up the left (8) or right half (9) of the detection fields, 90° in each case.
i
Always use the entire cover plate! Cutting out the cover plate to a smaller angle will result
in malfunctions.
o
Fit cover plate on sensor window.
5 Appendix
Remove empty batteries immediately and dispose of in an environmentally friendly
manner. Do not throw batteries into household waste. Consult your local authorities
about environmentally friendly disposal. According to statutory provisions, the end
consumer is obligated to return used batteries.
5.1 Technical data
Rated voltage
DC 3 V
Battery type
1×Lithium CR 2450N
Ambient temperature
+5 ... +35 °C
Relative humidity
max. 65 % (No moisture condensation)
Brightness setting
approx. 0 ... 80 lx (and day operation)
Installation height
1.10 m
Detection angle
180 °
Detection area
approx. 10 x 12 m
Radio frequency
433.05 MHz ... 434.79 MHz
Transmitting range in free field
typ. 60 m
7/8
32552843
J0082552843
16.08.2016
Radio Management
Radio automatic switch 180°
