Art.-No.: 4071.0x LED, 4072.0x LED
Art.-No.: 8471.0x LED W, 8472.0x LED W
4.2.4 Functional description
4.2.4.1 Rocker switch and button arrangement
In the push-button bus coupler, switches are used depending on the device version - 1-gang or
2-gang - rocker switches or two-circuit switching rockers (figure 4). In the "neutral position"
device version ((8) + (9)), the rocker switch can be operated on both sides (top or bottom). In
the ETS, the operation concept can then be configured to rocker function (the same KNX
function on both control elements) or alternatively to push-button function (the same or different
KNX functions on the control elements). In the "neutral position" version, the rocker switches
are upright when they are not pressed.
In the "switch position" version ((6) + (7)), the rocker switch can only be operated on one side
(e.g. at the bottom) so that only push-button functions are executable. In this case, the rocker
switch is slanting when it is not pressed.
The figure below shows the device variants and illustrates the position of the rocker switches
and buttons and the status-LED.
Figure 4: Position of the rocker switches, buttons and status-LED of the device variants
(6) Push-button bus coupler 1-gang, switch position
(7) Push-button bus coupler 2-gang, switch position
(8) Push-button bus coupler 1-gang, neutral position
(9) Push-button bus coupler 2-gang, neutral position
Page 19 of 34
Software "10Fx11"
Functional description
