Art.-No.: 4071.0x LED, 4072.0x LED
Art.-No.: 8471.0x LED W, 8472.0x LED W
4.2.2 Notes on software
ETS project design and commissioning
For configuration and commissioning of the device, ETS3.0 from Version "d" Patch "A" onwards
or ETS4 is required. Through use of these ETS version, advantages are gained with regard to
the programming process and the parameter presentation.
Using the application programs
The device variants...
-
1-gang switch position
-
1-gang neutral position
-
2-gang switch position
-
2-gang neutral position
...each have their own application programs. When configuring and commissioning the push-
button bus coupler, make sure that the product catalogue entry used in the ETS project
matches the application program for the installed device hardware.
The ETS prevents the programming of application programs of devices with switch position in
devices with neutral position or vice versa. The ETS does not intercept the programming of an
application program of the 1-gang device variant in a 2-gang device (or vice versa). Undesirable
functions can result here due to missing or redundant buttons/LED if the wrong application
programs are used.
i
The device variants of the "FM" and "IP44" designs have the same functionality. Hence, the
"push-button bus coupler 1-gang switch position FM" is configured with the same
application program and commissioned just like the "push-button bus coupler 1-gang
switch position IP44". This is basically the same for all other device variants of the designs.
Page 14 of 34
Software "10Fx11"
Notes on software