5.2 Commissioning
Downloading the physical address
The device must have been connected and ready for use.
The programming button (6) and LED (7) must be accessible on the rear side of the device.
Configuration and startup with ETS2 version 1.3a or later.
o
Press the programming button (6).
The programming LED (7) is illuminated.
o
Assign physical address.
The programming LED ceases to be illuminated
o
Note the physical address on the rear side of the device.
Downloading the user software
Configuration and commissioning are performed with the aid of an ETS plug-in that replaces the
ETS Parameters window.
i
Copying of the device is only possible with version ETS3 onwards. The same applies for
the functions "Copy project", "Split project", "Merge project" and "Shrink database".
Recommendation: Due to large data volumes it is recommended to program the user software
via the integrated RS232 interface (10). More detailed information on this is provided in the
product documentation.
The connection to the PC requires an RS232 cable with 1:1 wiring. Do not exceed max. length
of 15 m.
i
Connect one device to the PC only.
o
After installation of the device: Remove design frame from the device, remove device.
o
Establish a connection with the programming PC via the RS232 line.
o
Program the user software.
o
After the programming procedure: Remove RS232 cable, mount device securely again.
Attach the design frame and push it on.
6 Appendix
6.1 Technical data
Rated voltage
AC 230 V ~
Mains frequency
50 / 60 Hz
Power consumption KNX
typical 150 mW
Ambient temperature
-5 ... +45 °C
Storage/transport temperature
-25 ... +70 °C
Protection rating
IP 54 (depending on installation)
Dimensions
External dimensions W×H×D
213×125×68 mm
Installation dimensions W×H×D
205×115×62 mm
Screen
diagonal
140 mm
Dimensions W×H
123×69 mm
Connection
Single stranded
0.5 ... 4 mm²
finely stranded with conductor sleeve
0.5 ... 1.5 mm²
finely stranded without conductor sleeve
0.5 ... 2.5 mm²
KNX
KNX medium
TP 1
Commissioning mode
S mode
Rated voltage KNX
DC 21 ... 32 V SELV
Connection mode KNX
Connection terminal
4/5
82507913
17.08.2010
LCD mini panel
