EN
50
Operating Manual: RWM200 - Smoke Alarm Device
6
Putting into
operation
Note the following when putting into
operation:
(1)
Push the splint pin sideways off of
activation button.
(2)
Push activation button flush.
Short acoustic signal
5
The device is activated.
Alarm stop
You can stop an alarm with or without fire.
If there is still a risk of fire after
an alarm stop, the switched-off
devices ring again after 10 minutes.
You can stop the alarm directly on
the device:
f
Press the testing / stop button on
the device.
7 Fault and error
messages
The device automatically checks its opera-
tional readiness once a minute. The device
displays functional limitations in the form
of error and alarm messages.
If the device detects environmental influ
-
ences differing from the rule, it regulates
the sensitivity of its detection electronics
automatically.
7.1 Error messages
The following messages are considered
error messages:
•
Battery error message
•
Contamination message
•
Alarm without cause of fire
