0708
.GB
E 2
operation of the forklift truck. Failure to perform regular servicing can lead to truck
failure and poses a potential hazard to personnel and equipment.
M
The application conditions of an industrial truck have a considerable impact on the
wear of the service components.
We recommend an application analysis carried out on site by a Jungheinrich
customer service adviser to draw up specific service intervals to prevent damage
caused by wear.
The service intervals stated are based on single shift operation under normal
operating conditions. They must be reduced accordingly if the truck is to be used in
conditions of extreme dust, temperature fluctuations or multiple shifts.
The oil level must be checked every 4000 service hours, or at least every 2 years, and
topped up as required (type HV 32 only, capacity: 0.36 litres) and the links lubricated
with a MoS2 based lubricant.
During the run-in period – after approx. 100 service hours – the owner must check
the wheel nuts/bolts and re-tighten if necessary.
4
Recommissioning
The truck may only be restored to service after cleaning or repair work once the
following operations have been performed.
– Bleed the hydraulic system (see chapter C).
0708
.GB
E 2
operation of the forklift truck. Failure to perform regular servicing can lead to truck
failure and poses a potential hazard to personnel and equipment.
M
The application conditions of an industrial truck have a considerable impact on the
wear of the service components.
We recommend an application analysis carried out on site by a Jungheinrich
customer service adviser to draw up specific service intervals to prevent damage
caused by wear.
The service intervals stated are based on single shift operation under normal
operating conditions. They must be reduced accordingly if the truck is to be used in
conditions of extreme dust, temperature fluctuations or multiple shifts.
The oil level must be checked every 4000 service hours, or at least every 2 years, and
topped up as required (type HV 32 only, capacity: 0.36 litres) and the links lubricated
with a MoS2 based lubricant.
During the run-in period – after approx. 100 service hours – the owner must check
the wheel nuts/bolts and re-tighten if necessary.
4
Recommissioning
The truck may only be restored to service after cleaning or repair work once the
following operations have been performed.
– Bleed the hydraulic system (see chapter C).
Summary of Contents for AM 20T
Page 1: ...Operating instructions 51093842 AM 20T 01 07 07 08 G...
Page 5: ...0108 GB...
Page 9: ...0107 GB A 2...
