11
.1
4
E
N
208
Clamping device
Air conditioning system
Crane hook
Load backrest
Hydraulic operations
W A B C
1
Test the acknowledgement key.
t
2
Test the hose reel and check for leaks and damage.
t
3
Check axial play of the front and rear rollers and adjust if necessary.
t
4
Check attachment is properly secured to the truck and the
supporting elements.
t
5
Test attachment, check settings and check for damage.
t
6
Check sliding blocks are complete.
t
7
Check attachment bearing points, guides and stops for wear and
damage, grease and clean these components.
t
8
Check attachment lubrication; clean and lubricate if necessary.
t
9
Check hydraulic ports and tighten if necessary.
t
10 Check cylinder seals.
t
11
Check cylinder piston rods and bushings.
t
Chassis and Superstructure
W A B C
1
Test air conditioning system and its settings and check its
components for damage.
t
2
Note: The air conditioning system must only be serviced every two
years or 2000 service hours by specialist personnel.
3
Visually inspect the filter and replace if necessary.
t
4
Check temperature reading at the outlet of the ventilation nozzles
against manufacturer's ratings.
t
Hydraulic operations
W A B C
1
Check attachment is properly secured to the truck and the
supporting elements.
t
Hydraulic operations
W A B C
1
Check attachment is properly secured to the truck and the
supporting elements.
t
Summary of Contents for DFG 660
