221
11
.1
4
E
N
Impact sensor
Sideshifter
Seat heating
Road traffic approval (StVZO)
Boom
Weigher sensors / switches
Electrical System
W A B C
1
Check impact sensor is secure and check for damage.
t
Hydraulic operations
W A B C
1
Test the hose reel and check for leaks and damage.
t
2
Check axial play of the front and rear rollers and adjust if necessary.
t
3
Check attachment is properly secured to the truck and the
supporting elements.
t
4
Test attachment, check settings and check for damage.
t
5
Check sliding blocks are complete.
t
6
Check attachment bearing points, guides and stops for wear and
damage, grease and clean these components.
t
7
Check attachment lubrication; clean and lubricate if necessary.
t
8
Check hydraulic ports and tighten if necessary.
t
9
Test the sideshifter, check settings and check for damage.
t
10 Check cylinder seals.
t
11
Check cylinder piston rods and bushings.
t
Electrical System
W A B C
1
Check electrical wiring for damage (insulation damage,
connections). Make sure wire connections are secure.
t
Electrical System
W A B C
1
Test lighting.
t
Hydraulic operations
W A B C
1
Check attachment is properly secured to the truck and the
supporting elements.
t
Electrical System
W A B C
1
Test weigher system and check for damage.
t
Summary of Contents for DFG 660
