11
.1
4
E
N
100
6.2.1 Starting procedure for the DFG
Procedure
•
• Insert the key in the key switch (88) and turn it to the “2”
position.
• The pre-heat indicator lamp lights up and goes out
automatically as soon as the required pre-heat time (approx.
4 seconds) has been reached.
• All the indicators light up briefly to test operation.
Z
All the indicators except for the engine oil pressure display,
parking brake indicator, indicator lamp for neutral position and battery control light
(85) should go out after a short while. If not, stop the start-up process and rectify
the fault.
•
• Turn the key to position "3".
Z
Only apply the starter for a maximum of 15 seconds
without interruption. The truck is equipped with an
immobiliser which prevents it from starting again while the
engine is running.
• Release the key as soon as the engine starts. The key
automatically reverts to the "2" position.
Z
All indicators lights except for neutral position and parking
brake should go out as soon as the engine starts. If not,
stop the engine immediately and rectify the fault.
Truck is operational.
3
88
85
88
Summary of Contents for DFG 660
