E 11
0903
.GB
5
Troubleshooting
This chapter allows the user to locate and eliminate simple malfunctions by himself.
When trying to locate a fault, proceed in the order shown in the table.
A
If it was not possible to render the truck ready for operation after performing the
“remedial actions”, please contact the customer service because specially trained
and qualified service personnel may carry out further repairs only.
Fault
Possible cause
Remedial action
Truck does not
move
– Battery connector not
connected
– Check battery plug and plug in,
if necessary
– Main switch (EMERGENCY
STOP) pressed
– Unlock main switch
(EMERGENCY STOP)
– Key switch in position “0”
– Set the key switch to position “I”
– Battery charge too low
– Check battery charge,
charge battery if necessary
– Door contact switch not
actuated
– Close driver door
– Fuse defective
– Check fuses F1 and 1F1
Load cannot
be lifted
– Truck not ready for operation
– Perform all remedial actions
listed under the fault “Truck
does not move”
– Hydraulic oil level too low.
– Check the hydraulic oil level
– Fuse defective
– Check fuse 2F1
E 11
0903
.GB
5
Troubleshooting
This chapter allows the user to locate and eliminate simple malfunctions by himself.
When trying to locate a fault, proceed in the order shown in the table.
A
If it was not possible to render the truck ready for operation after performing the
“remedial actions”, please contact the customer service because specially trained
and qualified service personnel may carry out further repairs only.
Fault
Possible cause
Remedial action
Truck does not
move
– Battery connector not
connected
– Check battery plug and plug in,
if necessary
– Main switch (EMERGENCY
STOP) pressed
– Unlock main switch
(EMERGENCY STOP)
– Key switch in position “0”
– Set the key switch to position “I”
– Battery charge too low
– Check battery charge,
charge battery if necessary
– Door contact switch not
actuated
– Close driver door
– Fuse defective
– Check fuses F1 and 1F1
Load cannot
be lifted
– Truck not ready for operation
– Perform all remedial actions
listed under the fault “Truck
does not move”
– Hydraulic oil level too low.
– Check the hydraulic oil level
– Fuse defective
– Check fuse 2F1
Summary of Contents for EKE 30-2 ac
