Jungheinrich KMS 100, Operating Instructions Manual

1298

.GB

F 14

5.14

Recommissioning the truck 

Recommissioning of the truck following the performance of cleaning or maintenance
work is permitted only after the following operations have been performed: 

– Check the horn for proper functioning.
– Check the main switch (Emergency-STOP) for correct function.
– Check the brake for correct function.

6

Taking the floor conveyor out of service 

If the truck is to be decommissioned for more than two months, it must be parked in
a frost-free and dry location and all measures to be taken before, during and following
decommissioning must be performed as detailed below.

m

During decommissioning the truck must be jacked up ensuring that the wheels are
clear of the ground. Only this measure will ensure that wheels and wheel bearings do
not suffer damage.

If the truck is to be decommissioned for periods in excess of six months, the service
of the manufacturer must be contacted for further measures to be taken.

6.15

Operations to be performed prior to decommissioning 

– Thoroughly clean the truck.
– Check the brakes.
– Check the hydraulic oil level and refill, if required (se chapter F).
– Apply a thin film of oil or grease to all parts not protected by a paint coating.
– Grease the truck as detailed in the lubrication chart (refer to chapter F).
– Recharge the battery (see chapter D).
– Disconnect and clean the battery. Apply pole grease to the battery terminals.

A

In addition to this, all instructions as given by the battery supplier have to be obser-
ved.

– Spray all exposed electrical contacts with a suitable contact spray.

6.16

Measures to be taken during decommissioning 

Every 2 months:

– Recharge the battery (see chapter D).

m

For battery-driven trucks:
Regular recharging of the battery is very important. Otherwise, excessive depletion
of the battery would occur caused by self-discharging, which will result in the destruc-
tion of the battery caused by sulfatisation.

1298

.GB

F 14

5.14

Recommissioning the truck 

Recommissioning of the truck following the performance of cleaning or maintenance
work is permitted only after the following operations have been performed: 

– Check the horn for proper functioning.
– Check the main switch (Emergency-STOP) for correct function.
– Check the brake for correct function.

6

Taking the floor conveyor out of service 

If the truck is to be decommissioned for more than two months, it must be parked in
a frost-free and dry location and all measures to be taken before, during and following
decommissioning must be performed as detailed below.

m

During decommissioning the truck must be jacked up ensuring that the wheels are
clear of the ground. Only this measure will ensure that wheels and wheel bearings do
not suffer damage.

If the truck is to be decommissioned for periods in excess of six months, the service
of the manufacturer must be contacted for further measures to be taken.

6.15

Operations to be performed prior to decommissioning 

– Thoroughly clean the truck.
– Check the brakes.
– Check the hydraulic oil level and refill, if required (se chapter F).
– Apply a thin film of oil or grease to all parts not protected by a paint coating.
– Grease the truck as detailed in the lubrication chart (refer to chapter F).
– Recharge the battery (see chapter D).
– Disconnect and clean the battery. Apply pole grease to the battery terminals.

A

In addition to this, all instructions as given by the battery supplier have to be obser-
ved.

– Spray all exposed electrical contacts with a suitable contact spray.

6.16

Measures to be taken during decommissioning 

Every 2 months:

– Recharge the battery (see chapter D).

m

For battery-driven trucks:
Regular recharging of the battery is very important. Otherwise, excessive depletion
of the battery would occur caused by self-discharging, which will result in the destruc-
tion of the battery caused by sulfatisation.