Outstanding Issues
13
BXOS 4.1 R2 Software Release Notes
7.
Enter configuration mode using the following command:
cli@BX7000>
con
8.
Configure the gateway from the following prompt:
cli@BX7000#
To set the system to the factory default:
1.
Reboot the system.
The prompt displays:
Press ESC Key to enter into Field diagnostics
message.
2.
Press the
Esc
key.
The prompt displays:
Enter the password:
3.
Enter the password as
GetmeIn@7
.
Enter the password:
The system displays the following
Boot Menu
options:
1. Diagnostics Mode
2. Setup Mode
3. Exit and Continue
Enter the menu option number and press Enter key:
4.
Enter the menu option number as 2 for the Setup Mode:
Enter the menu option number and press Enter key:
2
The system enters into the SIDX setup mode.
SIDX>
5.
Set the system to the factory default using the
factorydefault
command:
SIDX>
factorydefault
The system requires a password to execute the command.
6.
Enter the password as
syrah
to set the system to the factory default:
Enter the password:
7.
The system reboots with the default factory configuration.
8.
After system reboot, access the gateway using the root account or CLI user
privileges.
9.
Enter configuration mode using the following command:
cli@BX7000>
con
10. Configure the gateway from the following prompt:
cli@BX7000#
For information about restoring the configuration file, see the
BXOS
Configuration Guide
.
In FRR set up with SAToP pseudowire, the primary and bypass tunnel statistics
are not updated after the traffic switches back to the bypass tunnel interface.
There is no workaround. [PR/446941]
