Outstanding Issues
9
BXOS 4.1 R2 Software Release Notes
If you configure the loopback address in a strict path in the RSVP tunnel
configuration, the tunnel does not come up. There is no workaround.
[PR/402069]
When you configure an ATM pseudowire in the AAL5 SDU mode, pass
pseudowire frames, and issue the
show statistics l2circuit
command, the cyclic
redundancy check (CRC) and size error counters under the
Packet Statistics
column display the wrong statistics. As a workaround, save the configuration
and reboot the gateway; the ATM pseudowire comes up with correct packet
statistics. [PR/404150]
While using ATM/AAL5 pseudowires in AAL5 SDU mode, CRC and size error
counters are wrongly incremented in the ATM to PSN direction, but there is no
impact to traffic, only statistics are wrongly reported. There is no workaround.
[PR/404150-2]
When the OSPF protocol is up on the PPP interface, PPP interface deletion fails.
As a workaround, disable the OSPF protocol on the PPP interface and then
delete the PPP interface. [PR/404259]
When two gateways are connected through a VLAN subinterface, traffic is
passed even if the admin state of the interface is down on one of the gateways.
There is no workaround. [PR/404654]
If you close the current SSH session when an image upgrade is in progress, you
cannot upgrade the image by re-opening a new SSH session. As a workaround,
do not terminate the SSH session when an image upgrade is in progress. You
can also reboot the gateway and open an SSH session to upgrade the image.
[PR/405319]
The BXOS CLI does not support the pipe (|) command to match and filter the
output. There is no workaround. [PR/406381]
You cannot delete or disable an existing segment or e2e-endpoint in ATM OAM
configuration over an ATM interface. As a workaround, delete and reconfigure
the ATM interface with required ATM OAM configuration. [PR/407982]
The traffic scheduler does not schedule traffic correctly if the configured
weights are not multiples of ten. There is no workaround. [PR/408434]
The CLI does not support commands to delete the
hold-time
,
strict-targeted-hellos
, and
keepalive-timeout
parameters at the [
edit protocols ldp]
hierarchy level. There is no workaround. [PR/410603]
When you configure fast re-route (FRR), the traffic failover time from the
primary tunnel to the backup tunnel is approximately 300 milliseconds. There
is no workaround. [PR/410625]
After configuring more PPP links and static routes and passing traffic through
those routes, if PPP links are deleted and recreated multiple times, the traffic is
lost. As a workaround, avoid deleting and recreating PPP links multiple times
when traffic is passing through those links. [PR/411490]
The gateway does not support statistics for shaper and scheduler. There is no
workaround. [PR/415309]
