9. Carefully replace the battery and
slide the lock to the right to secure
the battery.
10. Carefully replace the battery door
and lock the battery door latches.
WARNING: The battery door must
be properly seated and secured before
exposing the unit to water. Failure to
perform this step could lead to water
damage of the unit.
SUPPORT
Web: http://www.junipersys.com
Email: cedarsupport@junipersys.com
Phone: 435-753-1881
REGULATORY INFORMATION
This equipment has been tested and
found to comply with the limits for
a Class B digital device, pursuant to
part 15 of the FCC Rules. Operation
is subject to the following two
conditions: (1) This device may not
cause harmful interference, and (2) this
device must accept any interference
received, including interference that
may cause undesired operation.
These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and
can radiate radio frequency energy
and, if not installed and used in
accordance with the instructions, may
cause harmful interference to radio
communications. However, there is
no guarantee that interference will
not occur in a particular installation. If
this equipment does cause harmful
interference to radio or television
reception, which can be determined
by turning the equipment off and on,
the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving
antenna.
• Increase the separation between the
equipment and receiver.
• Connect the equipment to an outlet
on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced
radio/TV technician for help.
IMPORTANT: Changes or
modifications to this product not
authorized by the manufacturer could
void the radio frequency compatibility
and wireless compliance and negate your
authority to operate the product. The
use of noncompliant peripheral devices
could cause the emission of radiation not
within the limits set by part 15 of the FCC
rules. Only use peripheral devices tested
to provide electromagnetic compatibility
when connected to this unit.
EXPOSURE TO RADIO FREQUENCY
(RF) SIGNALS
Your device contains a radio transmitter
and receiver. The radiated output power
is far below the international radio
frequency exposure limits. These limits
are part of comprehensive guidelines
and establish permitted levels of RF
energy for the general population.
The guidelines are based on the safety
standards previously set by international
standards bodies:
• American National Standards
Institute (ANSI) IEEE. C95.1-1992.
• National Council on Radiation
Protection and Measurement
(NCRP). Report 86. 1986.
• International Commission on
Non-Ionizing Radiation Protection
(ICNIRP) 1996.
• Ministry of Health (Canada),
Safety Code 6.
29949-00_CT8X2_Manual.indd 5
29949-00_CT8X2_Manual.indd 5
12/17/20 2:14 PM
12/17/20 2:14 PM