To unpack the device:
1.
Cut the two straps that secure the carton to the skid, open the carton from the
top, and remove the box of accessories that sits on top of the device.
2.
Unlock the four plastic clips that hold the box to the skid by squeezing them in
their center and pulling out, and then lift the carton off the device.
3.
Remove the three screws that attach each of the two L-brackets to the device.
4.
To avoid scratching the device when removing it from the skid, detach one of
the L-brackets from the skid by removing the three screws.
Inspect the Components and Accessories
After you remove the equipment from the shipping containers:
■
Confirm the contents of each container.
■
Inspect all external surfaces and external connectors for visible signs of damage.
■
Inspect all accessories shipped with each unit.
■
Document any damage noted during your inspection.
■
Confirm that the device has the correct number and type of modules for your
ordered configuration.
If You Detect or Suspect Damage
If you detect or suspect damage to any equipment:
■
Contact the shipper responsible for delivery, and formally report the damage.
■
Contact your Juniper Networks sales representative or reseller.
Step 2: Install the Platform
■
Before You Begin Installation on page 4
■
Option: Install the Platform in Freestanding Mode on page 5
■
Option: Install the Platform in a Rack on page 5
Before You Begin Installation
Before installing the device:
■
Have a plan for installing the device that takes into consideration future
expansion.
■
Have the tools and accessories needed to complete the installation.
■
Be sure that the space requirement of 3 feet (90 cm) behind the device or rack
is met. Do not block air vents on the front or back of the router.
4
■
Step 2: Install the Platform
CTP150 Platform Quick Start Guide
