■
Prepare the equipment racks by measuring and marking space for each device
and plenum you plan to install.
■
See the “Safety Warnings” on page 15
Option: Install the Platform in Freestanding Mode
When installing the device on a table top or in any other freestanding mode, be sure
to leave enough space around the device for adequate ventilation. Position the chassis
with easy access to the connections that it needs for power, local communications,
and remote communications.
WARNING:
Two people are required to lift the device.
CAUTION:
To prevent electrostatic damage to the device and its components, make
sure persons handling the device wear an antistatic device.
Option: Install the Platform in a Rack
To install the device in a rack, you need:
■
Phillips screwdriver
■
Four 10-32 x 3/8 Phillips screws for each device to be installed
To install the device in the rack:
1.
With one person standing on the left side of the device and another standing on
the right side, lift the device into the rack.
2.
Position the device in its designated location in the equipment rack. Make sure
the holes of the mounting brackets align evenly with the holes of the equipment
rack on both sides.
3.
Starting at the bottom of the device, have the second person secure the device
in the equipment rack by using the 10-32 x 3/8 Phillips screws.
Step 3: Install Modules and Other Components
■
Protect Modules and Slots on page 6
■
Required Tools and Safety Items for Installation on page 6
■
Safety Guidelines for Installing Modules on page 6
■
Install an Interface Module on page 7
■
Install CompactFlash Card and Replace Drive on page 8
Step 3: Install Modules and Other Components
■
5
Step 3: Install Modules and Other Components
