6.
Guide the module into the chassis by placing it between the guides of the selected
slot and pushing the module until it stops.
The module stops sliding when the ejectors make contact with the chassis.
CAUTION:
If you meet strong resistance when attempting to seat the module using
the ejectors, remove it from the chassis, and confirm that the slot is designed to hold
the component. Also, be sure that you have aligned the left and right edges in the
correct matching tracks.
7.
Insert the module into the midplane by simultaneously pressing both ejectors
inward and exerting forward pressure on the module. The small red release
buttons should click into place.
8.
Tighten the module's captive screws using a Phillips screwdriver.
NOTE:
Tighten the captive screws completely before installing an adjacent module
so that proper electromagnetic interference (EMI) gasket compression occurs. Failure
to do this can make it difficult to install adjacent modules.
Install CompactFlash Card and Replace Drive
The CTP150 model has a removable Type II CompactFlash card. The device should
be powered off when you insert or remove the Flash drive. Figure 2 on page 8
shows the Flash drive on the rear of the CTP150 chassis.
CAUTION:
Although you can remove CompactFlash cards from a running device,
we recommend that you do not do so. If you remove the card while data is being
written to or copied from the CompactFlash card, data can be lost or corrupted.
Therefore, we strongly recommend that you shut down the device before removing
or inserting a CompactFlash card.
Figure 2: CTP150 Platform Flash Drive
g004481
Fans
Compact
Flash drive
Handle
AC power
cord inlet
Ejector lever
8
■
Step 3: Install Modules and Other Components
CTP150 Platform Quick Start Guide
