• ESD grounding strap.
• Power cord or cords appropriate for your geographical location.
CAUTION: Before you connect power to the JATP400 appliance, ensure both power
supply ground terminals are grounded to meet the safety requirements and to ensure
proper operation.
To connect AC power to a JATP400 appliance:
1. To prevent damage to the equipment caused by static discharge, attach one end of an ESD strap to
an ESD point and fasten the other end around your bare wrist.
2. Ensure that the power supplies are fully inserted in the chassis and the latches are secure.
3. Locate the power cord or cords shipped with the JATP400 appliance.
4. Plug the power cord into the AC receptacle on the rear panel as shown in
.
If your appliance contains two power supplies, plug each of the power cords into each of the AC
receptacles.
Figure 13: Connecting the AC Power Cord
NOTE: Grounding for the appliances is provided through the power supply ground terminal.
Ensure that you connect the AC power supply module in the appliance to a grounded AC
power outlet by using an AC power cord (with the grounding pin) appropriate for your
geographical location.
5. Plug the other end of the power cord into a wall socket.
6. Press the Power button on the front panel.
7. Verify that the status LEDs of the power supply is lit solid green.
36
Summary of Contents for JATP400
