Connecting the JATP400 to Power
IN THIS SECTION
Connecting the JATP400 Appliance to Earth Ground | 35
Connecting AC Power Source to the JATP400 Appliance | 35
Connecting DC Power to the JATP400 Appliance | 37
Connecting the JATP400 Appliance to Earth Ground
To meet safety and electromagnetic interference (EMI) requirements and to ensure proper operation,
you must connect the device chassis to earth ground, if required by your site guidelines or installation.
Grounding for the JATP400 appliance is provided through the power supply ground. Ensure that you
connect the AC power supply module in the appliance to a grounded AC power outlet by using an AC
power cord (with the grounding pin) appropriate for your geographical location.
Connecting AC Power Source to the JATP400 Appliance
Before you connect AC power to the JATP400 appliance:
• Ensure that you have taken the necessary precautions to prevent electrostatic discharge (ESD)
damage.
• Ensure that you have connected the JATP400 appliance chassis to earth ground, if required by your
site guidelines or installation.
CAUTION: For installations that require a separate grounding conductor to the chassis,
have a licensed electrician complete this connection before you connect the appliance
to power. For instructions on connecting earth ground, see
Appliance to Earth Ground" on page 35
Required tools and parts:
35
Summary of Contents for JATP400
