Table 149: Components of a Preprovisioned Virtual Chassis Interconnected Across Multiple
Wiring Closets
(continued)
Location
Hardware
Uplink Module
Ports
Role
Member ID
Serial number
Switch
Wiring closet B
EX4200-24T
linecard
6
stu901
SWA-6
Wiring closet B
EX4200-24T
and XFP uplink
module
xe-7/1/0
linecard
7
vwx234
SWA-7
Wiring closet B
EX4200-24T
linecard
8
yza567
SWA-8
Wiring closet B
EX4200-48P
linecard
9
bcd890
SWA-9
Figure 21 on page 987 shows the different types of interconnections used for this Virtual
Chassis configuration. The rear view shows that the member switches within each wiring
closet are interconnected to each other using the dedicated VCPs. The front view shows
that the uplink module ports that have been set as VCPs and interconnected across the
wiring closets. The uplink module ports that are not set as VCPs can be configured as
trunk ports to connect to a distribution switch.
NOTE:
The interconnections shown in Figure 21 on page 987 are the same as
they would be for a configuration that was not preprovisioned across wiring
closets.
Copyright © 2010, Juniper Networks, Inc.
986
Complete Software Guide for Junos
®
OS for EX Series Ethernet Switches, Release 10.3
Summary of Contents for JUNOS OS 10.3 - SOFTWARE
