Troubleshooting
To troubleshoot a Virtual Chassis configuration that is interconnected across wiring
closets, perform this task:
Troubleshooting Nonoperational VCPs
Problem
An uplink VCP shows a status of
down
.
Solution
Check the cable to make sure that it is properly and securely connected to the interfaces.
•
•
If the VCP is an uplink module interface, make sure that it has been explicitly set as an
uplink VCP.
•
If the VCP is an uplink module interface, make sure that you have specified the options
(
pic-slot
,
port
, and
member
) correctly.
Related
Documentation
Example: Configuring a Virtual Chassis with a Master and Backup in a Single Wiring
Closet on page 947
•
•
Example: Expanding a Virtual Chassis Configuration in a Single Wiring Closet on page 952
•
Example: Setting Up a Multimember Virtual Chassis Access Switch with a Default
Configuration on page 957
•
Setting an Uplink Module Port as a Virtual Chassis Port (CLI Procedure) on page 1023
•
Reverting to the Default Factory Configuration for the EX Series Switch on page 427
Example: Configuring Automatic Software Update on Virtual Chassis Member Switches
The automatic software update feature automatically updates the Juniper Networks
Junos OS version on prospective member switches as they are added to a Virtual Chassis
configuration of Juniper Networks EX4200 Ethernet Switches so the new member switch
immediately joins the Virtual Chassis configuration and is put in the active state. If the
software version on the new switch is not the same as the version running on the master,
the master keeps the new switch in the inactive state. If you have not enabled the
automatic software update feature, you will have to manually install the correct software
version on each prospective member switch as it is added to the Virtual Chassis
configuration.
This example describes how to configure the Virtual Chassis automatic software update
feature:
•
Requirements on page 1008
•
Overview and Topology on page 1008
•
Configuration on page 1008
•
Verification on page 1009
1007
Copyright © 2010, Juniper Networks, Inc.
Chapter 44: Virtual Chassis—Configuration Examples
Summary of Contents for JUNOS OS 10.3 - SOFTWARE
