1.
Log in to the master Routing Engine’s console.
For information on logging in to the Routing Engine through the console port, see
“Connecting and Configuring an EX Series Switch (CLI Procedure)” on page 187.
2.
Enter the Junos OS CLI configuration mode:
a. Start the CLI from the shell prompt:
user@switch:RE% cli
You will see:
{master}
user@switch>
b. Enter configuration mode:
user@switch> configure
You will see:
{master}[[edit]
user@switch#
3.
Disable GRES (graceful Routing Engine switchover):
[edit]
user@switch# deactivate chassis redundancy graceful-switchover
4.
Save the configuration change on both Routing Engines:
[edit]
user@switch# commit synchronize
NOTE:
To ensure the most recent configuration changes are committed
before the software upgrade, perform this step even if GRES was previously
disabled.
5.
Exit out of the CLI configuration mode:
[edit]
user@switch# exit
6.
(Optional) Back up the current software configuration to a second storage option.
See the
Junos OS Installation and Upgrade Guide
at
http://www.juniper.net/techpubs/software/junos/index.html
for instructions on
performing this task.
Copyright © 2010, Juniper Networks, Inc.
80
Complete Software Guide for Junos
®
OS for EX Series Ethernet Switches, Release 10.3
Summary of Contents for JUNOS OS 10.3 - SOFTWARE
