NOTE:
When you specify the same AS number in more than one routing
instance on the local routing device, you must configure the same number
of loops for the AS number in each instance. For example, if you configure a
value of 3 for the loops statement in a VRF routing instance that uses the
same AS number as that of the master instance, you must also configure a
value of 3 loops for the AS number in the master instance.
Use the independent-domain option if the loops statement must be enabled
only on a subset of routing instances.
The remaining statement is explained separately.
Required Privilege
Level
routing—To view this statement in the configuration.
routing-control—To add this statement to the configuration.
Related
Documentation
•
independent-domain
•
Configuring AS Numbers for BGP
•
4-Byte Autonomous System Numbers Overview
•
Juniper Networks Implementation of 4-Byte Autonomous System Numbers
•
Configuring 4-Byte Autonomous System Numbers
1735
Copyright © 2010, Juniper Networks, Inc.
Chapter 73: Configuration Statements for Layer 3 Protocols
Summary of Contents for JUNOS OS 10.3 - SOFTWARE
