Output Fields
Table 259 on page 2078 describes the output fields for the
show bgp neighbor
command.
Output fields are listed in the approximate order in which they appear.
Table 259: show bgp neighbor Output Fields
Field Description
Field Name
Address of the BGP neighbor. The address is followed by the neighbor’s port number.
Peer
AS number of the peer.
AS
Address of the local routing device. The address is followed by the peer’s port number.
Local
Type of peer:
Internal
or
External
.
Type
Current state of the BGP session:
•
Active
—BGP is initiating a transport protocol connection in an attempt to connect to a peer. If the
connection is successful, BGP sends an Open message.
•
Connect
—BGP is waiting for the transport protocol connection to be completed.
•
Established
—The BGP session has been established, and the peers are exchanging update messages.
•
Idle
—This is the first stage of a connection. BGP is waiting for a Start event.
•
OpenConfirm
—BGP has acknowledged receipt of an open message from the peer and is waiting
to receive a keepalive or notification message.
•
OpenSent
—BGP has sent an open message and is waiting to receive an open message from the
peer.
State
Internal BGP flags:
•
Aggregate Label
—BGP has aggregated a set of incoming labels (labels received from the peer)
into a single forwarding label.
•
CleanUp
—The peer session is being shut down.
•
Delete
—This peer has been deleted.
•
Idled
—This peer has been permanently idled.
•
ImportEval
—At the last commit, this peer was identified as needing to reevaluate all received
routes.
•
Initializing
—The peer session is initializing.
•
SendRtn
—Messages are being sent to the peer.
•
Sync
—This peer is synchronized with the rest of the peer group.
•
TryConnect
—Another attempt is being made to connect to the peer.
•
Unconfigured
—This peer is not configured.
•
WriteFailed
—An attempt to write to this peer failed.
Flags
Copyright © 2010, Juniper Networks, Inc.
2078
Complete Software Guide for Junos
®
OS for EX Series Ethernet Switches, Release 10.3
Summary of Contents for JUNOS OS 10.3 - SOFTWARE
